60 positions per side over 2.7 km. Click a node to open it. Grey cells are
positions with no device installed yet. A node is pinned to its cell by
the side and position device attributes;
chainage_m derives the position if that is not set. Cells
with a dashed outline are placed by guesswork because
neither was provisioned, so their position is not authoritative.
Nodes
Select a node on the Fleet tab.
—
——
Live load
—kN
Baseline (dead load)
—kN
Trigger threshold
—kN
Mode
—
Calibration
—
Backlog
—
queued on the node
Passage peaks and dead load
Blue dots are the peak load of each detected passage —
one dot per train, not a continuous signal. The grey dashed
line is the baseline the node tracks as dead load: it should
drift slowly with temperature, and a step change in it is a structural
signal worth investigating. The orange line is the
trigger threshold; anything below it was never recorded.
Node detail
Device name—
Label—
Placement—
Calibration source—
Raw HX711—
Samples taken—
Sensor faults—
Records stored / dropped—
Fatigue state
Cumulative Miner damage—
Total rainflow cycles—
Curve calibrated—
Passages
—
Peak load seen
—kN
Rainflow cycles
—
in this window
Damage accrued
—
in this window
Mean duration
—
per passage
Flagged
—
Remaining fatigue life
Passage peaks over time
Traffic rate
Peak load distribution
Load spectrum — rainflow cycles by range
Cycle counts are the trustworthy fatigue output. They are measured, not
derived from an assumed stress conversion.